Fine bonding coat — UFIX FINE BOND
UFIX FINE BOND

Care should be taken to ensure that UFB is thoroughly mixed. Small quantities (up to 10kg) can be mixed by hand using a suitable mixing drum or bucket. Greater quantities must be mixed with a mechanical forced mixer with a high shear stirrer. Use potable water while mixing and add water into the mixing vessel and with a mixer in operation, add one full bag of UFB and mix for 3 to 5 minutes until a fully uniform and homogeneous mix is achieved. Dependent on the ambient temperature and the desired consistency the amount of water required may vary slightly but should not exceeded 5 liters. per 20kg of UFB. Excess mixing water may result surface crazing, cracking as well as lower strength and adhesion. Note: In all cases UFB must be added to water.

Setting begins after 30-45 minutes (at 250C substrate and ambient temperature) and ends after 75-90 minutes. The working period depends very much on the product temperature and on the amount of mixing water added. Therefore, the times given above should be regarded as a guideline. The lower the temperature, the longer the setting time. The less water added, the shorter the setting time. The addition of water to the mortar after it has started to stiffen is not recommended and the product should be discarded.

Complete per the approved technical data sheet and batch documentation.

Complete per the approved technical data sheet and batch documentation.